Tip for the article "Umlaute on LCD"

Hello and welcome to our blog article today.

 

A few days ago, we presented you with a Post shown how to output self-created characters such as umlauts on a 1602 or 2004 LC display.

However, the character table published there already contains the characters for "äöüß°" and "a". For many applications, these would be enough.

However, because the table does not adhere to the UTF-8 standard, these characters cannot be easily output.

However, we can instruct the chip directly to output a specific character via a so-called escape sequence.

An escape sequence is a combination of characters in technical informatics that does not represent text, but is intercepted by the device and performs a special function.

Typically, it starts with a backslash, followed by a number.

This allows the characters mentioned initially to be output as follows:

  

  Lcd.Print("XE1"); outputs an ä   Lcd.Print("XEF"); gives a ö   Lcd.Print("XF5"); gives an ü   Lcd.Print("XE2"); gives a ß   Lcd.Print("XDF"); outputs a °   Lcd.Print("XE4"); outputs a   Lcd.Print("XF4"); outputs a

To end an escape sequence, you can insert a wider backslash at the end. For example, to use the output "Food: 23 °C" on the display, you can use the following spelling:

 

 

  Lcd.Print("K xF5"che: 23 xDF-C");

We hope that our tips for correctly displaying special characters and umlauts on LC displays will prove useful in your projects and look forward to your feedback.

I wish you every success in your projects and say goodbye to the next contribution.

 

Yours Markus Neumann

  

 

 

DisplaysSpecials

2 comments

Werner

Werner

Falls es jemanden interessiert: Ich habe mich daran gesetzt und die LCD Library so geändert, dass man nun im Fließtext wie gewohnt Umlaute verwenden kann. Also ein einfaches lcd.print(“Grüße aus Österreich”); ist möglich. Der Library findest du hier zum Download: https://werner.rothschopf.net/202003_arduino_liquid_crystal_umlaute.htm

Malke

Malke

Guten Abend,
der Hinweis hat mich weitergebracht. Deshalb ein herzliches Dankeschön !!!
Nun fehlt mir nur noch der Code für das große !Ü!

Gruss

Dietmar Malke

Leave a comment

All comments are moderated before being published

Recommended blog posts

  1. Install ESP32 now from the board manager
  2. Lüftersteuerung Raspberry Pi
  3. Arduino IDE - Programmieren für Einsteiger - Teil 1
  4. ESP32 - das Multitalent
  5. OTA - Over the Air - ESP programming via WLAN